Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac Solstice L4-2.4LFACTORY OEM SERVICE PROCEDURE
Fuel Tank Pressure Sensor: Service and Repair
Fuel Tank Pressure Sensor Replacement
Removal Procedure
Notice: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.
1. Remove the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement (Service and Repair) .
2. Remove the fuel pump module access cover bolts.
3. Remove the access cover.
4. Disconnect the fuel tank pressure sensor electrical connector (5).
5. Remove the fuel tank pressure sensor (2).
Installation Procedure
1. Install the fuel tank pressure sensor (2).
2. Connect the fuel tank pressure sensor electrical connector (5).
3. Install the fuel pump module access cover.
Notice: Refer to Fastener Notice (Fastener Notice) .
4. Install the access cover bolts.
Tighten the bolts to 10 N.m (89 lb in).
5. Install the rear compartment trim panel. Refer to Rear Compartment Trim Panel Replacement (Service and Repair) .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
