2008 Pontiac Solstice Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Circuit/System Verification

WARNING: This page is about a different car, the 2008 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, verify that the side object detection (SOD) system indicators located in the outside rearview mirrors illuminate briefly and turn OFF for a system self test.
    • If both SOD indicators do not come ON briefly for a system self test and the driver information center (DIC) displays SIDE BLIND ZONE ALERT SYSTEM OFF, the SOD system has been disabled from the DIC by the driver and is operating normally.
  • If both SOD indicators come ON and stay ON after the system self test and the DIC displays CLEAN SIDE BLIND ZONE ALERT SYSTEM, check for contamination on the fascia and sensor surface making sure they are clean.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.