Sunroof Control Module Programming and Setup (2 Connector System)

2008 Pontiac Grand Prix V6-3.8LSECTION Sunroof Control Module Programming and Setup (2 Connector System)


Sunroof Control Module Programming and Setup (2 Connector System)

This programming and setup is used for the 2 connector Sunroof System that uses the sunroof control module.


Sunroof Control Module Replacement

If the sunroof control module is replaced, the sunroof track timing synchronization must be performed. Refer to Sunroof Track Timing/Synchronization (PES) (Service and Repair) .


Sunroof Control Module Reprogramming

This component is not re-programmable.


Sunroof Control Module Re-Initialization: May Be Due To Related Component Service

If the sunroof control module requires re-initialization, refer to Sunroof Track Timing/Synchronization (PES) (Service and Repair) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.