Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac G6 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Engine Control Module: Locations
Front of Vehicle/Engine Compartment Component Views
Left Rear of Engine Compartment Components
1 - Battery
2 - Electronic Brake Control Module (EBCM)
3 - X101
4 - G103
5 - Fuse Block - Underhood
6 - Engine Control Module (ECM)
7 - Engine Control Module (ECM) X3
8 - Engine Control Module (ECM) X2
9 - Engine Control Module (ECM) X1
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.