Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac G6 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Body Control Module: Service and Repair
Body Control Module Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the right console trim panel.
3. Remove the body control module (BCM) screws.
4. Remove the BCM wire harness connectors.
5. Remove the BCM.
Installation Procedure
1. Install the BCM.
2. Install the BCM wire harness connectors.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
3. Install the BCM screws.
Tighten the screws to 2.5 Nm (22 lb in).
4. Install the right console trim panel.
5. Connect the negative battery cable.
6. For a new or remanufactured BCM, setup the BCM. Programming and Relearning
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.