Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac G6 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Body Control Module: Locations
Instrument Panel/Center Console Component Views
Lower Right of the I/P Components 3 of 3
1 - Body Control Module (BCM)
2 - Air Temp Sensor - Lower (C68)
3 - G203
Lower Center and Right of the I/P Components
1 - Radio, X1
2 - Body Control Module (BCM), X2
3 - HVAC Control Module, X2
4 - HVAC Control Module, X1
5 - Inflatable Restraint I/P Module Connector
6 - X207
7 - G201
8 - G203
9 - Body Control Module (BCM), X3
10 - Body Control Module (BCM), X1
11 - Body Control Module (BCM)4 - G201
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.