Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Pontiac G6 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Seat Temperature Control Module: Locations
Passenger Compartment/Roof Component Views
Under Driver Seat Components
1 - Seat Front Vertical Motor (AG1)
2 - Seat Horizontal Motor (AG1)
3 - Heated Seat Cushion Temperature Sensor - Driver (KA1)
4 - Seat Rear Vertical Motor (AG1)
5 - X300
6 - Heated Seat Control Module - Driver (KA1)
Under Front Passenger Seat Components (KA1)
1 - X310
2 - Heated Seat Control Module - Passenger
3 - Heated Seat Cushion Temperature Sensor - Passenger
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.