Park/Neutral Position Switch Adjustment

Tools Required

J 41545 Park/Neutral Switch Aligner

Adjustment

1. Disconnect the transaxle range switch electrical connectors from the switch.
2. Remove the shift control cable from the transaxle range switch lever.

3. Remove the transaxle range switch lever and nut

4. Make sure the transaxle manual shaft is in the Neutral position.
5. Loosen, DO NOT REMOVE the transaxle range switch bolts.

6. Insert the J 41545 as shown and rotate the switch until the tool drops onto position.

Notice: Refer to Fastener Notice .

7. Tighten the transaxle range switch bolts.

Tighten the range switch bolts to 20 N.m (15 lb ft).

8. Remove the alignment tool.

9. Install the transaxle range switch lever and nut

Tighten the transaxle range switch lever retaining nut to 35 N.m (26 lb ft).

Important: After adjusting the switch, verify the engine only starts in Park or Neutral. If the engine starts in any other position, adjust the switch.

10. Connect the transaxle range switch electrical connectors to the switch.
11. Install the shift control cable to transaxle range switch lever and verify proper operation.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Transmission Position Sensor/Switch: Adjustments

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?