2007 Pontiac Vibe AutomaticFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Positioning Vehicle Communication Interface Module
    GM1528369Courtesy of GENERAL MOTORS CORP.
  1. Position the VCIM in the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nuts (1).

    Tighten:  Tighten the nuts (1) to 4 N.m (36 lb in).

    3. Fig 2: Identifying Cellular Antenna And Navigation Radio Antenna Connectors
    GM1528368Courtesy of GENERAL MOTORS CORP.
  3. Position the seat to the most rearward position.
  4. Connect the cellular antenna and the navigation radio antenna connectors (1).
    5. Fig 3: Identifying Vehicle Communication Interface Module Electrical Connectors
    GM1528367Courtesy of GENERAL MOTORS CORP.
  5. Connect two vehicle communication interface module electrical connectors (1).
    6. CAUTION: Refer to Battery Disconnect Caution .
  6. Connect the battery ground cable.
    7. IMPORTANT: If replacing the vehicle communication interface module, you must reconfigure the OnStar® system.
  7. Reconfigure the OnStar® system. Refer to Control Module References for programming and setup information.
Chapter Navigation
Return to Chapter: Communication Interface Module Replacement
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.