Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Pontiac Solstice L4-2.0L TurboFACTORY OEM SERVICE PROCEDURE
Air Flow Meter/Sensor: Service and Repair
Mass Airflow Sensor Replacement
Removal Procedure
1. Disconnect the engine wiring harness electrical connector (1) from the mass air flow (MAF) sensor.
2. Remove the MAF sensor screws.
3. Remove the MAF sensor.
Installation Procedure
1. Install the MAF sensor.
Notice: Refer to Fastener Notice.
2. Install the MAF sensor screws.
Tighten the screws to 0.6 N.m (5 lb in).
3. Connect the engine wiring harness electrical connector to the MAF sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.