Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Pontiac Solstice L4-2.0L TurboFACTORY OEM SERVICE PROCEDURE
Scan Tool Data Definitions
Scan Tool Data Definitions
Battery Voltage
- The scan tool displays Normal/Out of Range. This is the current battery voltage available at the body control module (BCM) with normal being between 9 and 16 volts.
Door Ajar Switch
- The scan tool displays Door Closed/Door Ajar. The passenger door ajar switch input to the BCM, where an open door is displayed as Door Ajar.
Door Cylinder Switch
- The scan tool displays Voltage.
Door Cylinder Switch
- The scan tool displays Idle/Lock/Unlock/Invalid. The driver door key cylinder switch state.
Driver Door Ajar Sw.
- The scan tool displays Door Closed/Door Ajar. The driver door ajar switch input to the BCM, where an open door is displayed as Door Ajar.
Driver Door Lock Actuator Command
- The scan tool displays Idle/Lock/Unlock/Invalid. The state of the driver door lock actuator output.
Passenger Doors Lock Actuator Command
- The scan tool displays Idle/Lock/Unlock/Invalid. The state of the passenger door lock actuators outputs.
Trunk Ajar Switch
- The scan tool displays the status of the trunk ajar switch.
Trunk Motor
- The scan tool displays the current state of the trunk release motor.
Trunk Release Solenoid Command
- The scan too displays the status of the truck release solenoid output control.
Trunk Release Switch
- The scan tool displays the status of the trunk release switch input.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.