Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Pontiac Solstice Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Front Toe Adjustment
- Loosen the jam nut on the tie rod (2).
- Rotate the inner tie rod (1) to the required toe specification setting. Refer to Wheel Alignment Specifications .
- Tighten the jam nut on the tie rod.
Tighten: Tighten the front tie rod jam nut to 68 N.m (50 lb ft).
- Check the toe setting after tightening.
- Adjust the toe setting if necessary.
NOTE:
Refer to Fastener Notice
.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.