Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Pontiac Solstice Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location |
|---|---|
| Antenna (Base Radio) | Left of rear compartment lid. See Figure. |
| Audio Amplifier | Under right rear side of left seat. See Figure. |
| Blower Motor Resistor Assembly | Below blower motor. See Figure. |
| Cellular Microphone | At top of driver side windshield garnish molding. See Figure. |
| Cellular & Navigation Antenna | On rear compartment lid. See Figure. |
| Data Link Connector (DLC) | Under left side of dash. See Figure. |
| Data Link Terminal Resistor | Under left side of dash. See Figure. |
| Digital Radio Receiver | In rear compartment, behind right side trim panel. See Figure. |
| Engine Block Heater Connector | Right side of engine assembly. See Figure. |
| Generator | At left front of engine. See Figure. |
| Horn | At left front corner of engine compartment, attached to hinge bracket. See Figure. |
| Ignition Coils 1, 2, 3 & 4 | Top of engine, above respective cylinder. See Figure. |
| Seat Belt Pretensioner - Left | In driver seat belt retractor. See Figure. |
| Seat Belt Pretensioner - Right | In seat belt buckle. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
