2007 Pontiac Grand Prix BaseFACTORY OEM SERVICE PROCEDURE

Circuit/System Testing

  1. Verify that the transmitter is the correct transmitter for the vehicle.
    • If not the correct transmitter, replace the transmitter.
  2. Place the transmitter on the test pad of the J 43241Β 
    • If none of the buttons sounds the tone and illuminates the green light, replace the battery.
    • If one or more of the buttons sounds the tone and illuminates the green light, replace the transmitter.
  3. Operate the transmitter within the range of the vehicle. All of the keyless entry functions should operate normally.
    • If not all of the functions operate normally, program the transmitter.
  4. Ignition OFF, disconnect the harness connector at the RCDLR.
  5. Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit and ground.
    • If greater than 1.0 ohm, test the ground circuit for an open/high resistance.
  6. Ignition ON, verify that a test lamp illuminates between the battery positive voltage circuit and ground.
    • If the test lamp does not illuminate, repair the voltage supply circuit for a short to ground or an open/high resistance.
  7. If all circuits test normal, test or replace the RCDLR module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.