Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Pontiac G6 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Wiper Control Module: Service and Repair
WIPER DRIVE SYSTEM MODULE REPLACEMENT
REMOVAL PROCEDURE
IMPORTANT: The new wiper drive system module does not include the wiper motor nor the motor support bracket. You must install the old components to the new wiper system module.
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the bolts attaching the wiper module to the plenum.
4. Carefully lift the wiper module out of the plenum.
5. Disconnect the electrical connector from the wiper motor.
6. Disconnect the clip retaining the electrical harness to the wiper module.
7. Remove the wiper module assembly from the vehicle.
8. Remove the wiper motor.
INSTALLATION PROCEDURE
1. Install the wiper motor.
2. Connect the electrical connector to the wiper motor.
3. Connect the clip retaining the electrical harness to the wiper module.
4. Position the wiper module assembly into the plenum.
5. NOTE: Refer to Fastener Notice.
Install the fasteners attaching the wiper module assembly to the plenum.
Tighten the fasteners to 10 N.m (89 lb in).
6. Install the air inlet grille panel.
7. Install the wiper arms.
8. Inspect the washers for proper operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
