Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Pontiac G6 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Sunroof Motor/Actuator Initialization/Teach Process (Panoramic)
SUNROOF MOTOR/ACTUATOR INITIALIZATION/TEACH PROCESS (PANORAMIC)
INITIALIZATION PROCEDURE
Complete the Initialization Procedure whenever voltage has been applied to the control unit for the first time.
1. Hold the sunshade switch in the close position.
2. With the sunshade switch held closed, turn the rotary glass switch to the full open position and then to the full close position. Wait until both the sunshade and the windows close and remain closed for approximately 2 seconds.
3. Both the window and the sunshade drives, the motor and the controller, will stall at the full closed position. This is also known as the hard stop position. The initialization, or close stop, position is saved in electronically erasable programmable read-only memory (EEPROM).
IMPORTANT: The Initialization Procedure is not complete if one of the following events occurs before the initialization cycle has finished:
- The rotary switch does not remain in the closed position.
- The sunshade switch is released from the closed position.
- Ignition and/or battery power has been removed.
- If the Initialization Procedure is not carried out completely, it must be started over again.
TEACH PROCEDURE
IMPORTANT: Activate the Teach Procedure within 6 seconds after Initialization.
1. After the Initialization Procedure is complete, release the sunshade switch. Activate the close and release the sunshade switch 2 successive times.
2. Hold the switch in the active close position.
3. The window and the sunshade will travel to the full open position and then stall or hard stop approximately 1 second, then return to the full closed position. This is also known as the soft stop position.
4. Hold the switch for approximately 2 seconds. The profile data is saved to the EEPROM.
IMPORTANT: The Teach Procedure is not complete if one of the following occurs before the cycle has finished:
- The rotary switch is moved from the closed position.
- The sunshade switch is not held continuously in the activate close position.
- Ignition and/or battery power have been removed.
- The window and/or the sunshade have not reached the full soft stop close position after opening.
IMPORTANT: If the Teach Procedure is not carried out completely, only part of the profile data will be stored, and the Teach Procedure must be started again.
IMPORTANT:
- If the ignition is inactive, neither the window lamella nor the sunshade can be moved by the rotary switch.
- If the ignition is inactive, the sunshade cannot be moved by the sunshade switch.
- If the ignition goes inactive during window or sunshade movement after the Initialization or Teach Procedure, the window lamella and/or sunshade will stop.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
