Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Pontiac G6 L4-2.4LFACTORY OEM SERVICE PROCEDURE
Powertrain Management: Locations
Engine Controls Component Views
Left Rear of Engine Compartment
1 - Coolant Level Switch
2 - Battery
3 - Electronic Brake Control Module (EBCM)
4 - C101
5 - G103
6 - Fuse Block - Underhood
7 - Engine Control Module (ECM)
8 - Engine Control Module (ECM) C3
9 - Engine Control Module (ECM) C2
10 - Engine Control Module (ECM) C1
Front of the Engine (LE5)
1 - Fuel Injector 1
2 - Fuel Injector 2
3 - Fuel Injector 3
4 - Manifold Absolute Pressure (MAP) Sensor
5 - Fuel Injector 4
6 - Evaporative Emission (EVAP) Canister Purge Solenoid Valve
7 - Camshaft Position (CMP) Sensor - Intake
8 - Knock Sensor (KS)
9 - Engine Oil Pressure (EOP) Switch
10 - Crankshaft Position (CKP) Sensor
11 - Starter Solenoid
12 - Starter
13 - Intake Manifold
Rear of the Engine (LE5)
1 - Evaporative Emission (EVAP) Canister Purge Solenoid Valve
2 - Camshaft Position (CMP) Sensor - Exhaust
3 - Heated Oxygen Sensor (HO2S) 1
4 - Heated Oxygen Sensor (HO2S) 2
5 - Starter
6 - Engine Coolant Temperature (ECT) Sensor
7 - Camshaft Position (CMP) Sensor - Intake
Below the Left Side of the I/P
1 - Brake Pedal Position Sensor
2 - Accelerator Pedal Position (APP) Sensor
3 - Accelerator Pedal
4 - Brake Pedal
Under Right Rear of Vehicle
1 - Evaporative Emission (EVAP) Canister
2 - Evaporative Emission (EVAP) Canister Vent Solenoid Valve
3 - Fuel Tank Filler Neck
Top of Fuel Tank
1 - Fuel Tank Pressure (FTP) Sensor, Connector
2 - Fuel Pump and Sender Assembly
3 - Fuel Pump and Sender Assembly Connector
4 - Fuel Tank
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
