2007 Pontiac G6 L4-2.4LFACTORY OEM SERVICE PROCEDURE

Rear Toe Adjustment



Rear Toe Adjustment

Factory service manual diagram



1. Loosen the inner toe link cam bolt and nuts.
2. Rotate the cam bolt to the required toe specification settings. Refer to Measuring Wheel Alignment.

Notice: Refer to Fastener Notice.

3. Maintain the toe setting while tightening the cam bolt nut.

Tighten the rear suspension adjustment link lock nut to 110 Nm (81 lb ft).

4. Check the toe setting after tightening.
5. Adjust the toe setting if necessary.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.