Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Pontiac G6 Base, 2.4 BFACTORY OEM SERVICE PROCEDURE

Object Alarm Module Replacement (W/TB5)

WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Object Alarm Module Component View

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the left rear body side trim. Refer to Body Side Rear Trim Panel Replacement (w/o TB5) or Body Side Rear Trim Panel Replacement (w/TB5) . Remove the auxiliary HVAC module. Refer to Auxiliary HVAC Module Replacement .
1	Rear Object Alarm Module Retainer
2	Radio Speaker Amplifier Bracket Nut NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
3	Rear Object Alarm Module Procedure: Disconnect the electrical connectors.

Chapter Navigation

Return to Chapter: Repair Instructions

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.