Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Pontiac G5 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Splices
SPLICES LOCATION
| Component | Location |
|---|---|
| SP200 | Lower left of dash, below hood release. See Figure. |
| S100 | In ignition coil harness, top, right side of engine. See Figure. |
| S103 | In fuel injectors harness, top, left side of engine. See Figure. |
| S200 (Coupe) | In left front door harness, approximately 5.95 cm (2.25 in) from left front door lock switch. See Figure. |
| S200 (Sedan) | In left front door harness, approximately 7.85 cm (3 in) from left front door lock switch. See Figure. |
| S233 | In dash harness, lower left of dash, approximately 5 cm (2 in) from ambient light sensor breakout. See Figure. |
| S261 | In HVAC jumper harness, approximately 4.9 cm (2 in) from HVAC control assembly. See Figure. |
| S300 | In headliner harness, approximately 5.25 cm (2 in) from sunroof switch. See Figure. |
| S335 | In body harness, approximately 2.55 cm (1 in) from G301. See Figure. |
| S351 | In body harness, approximately 4 cm (1.5 in) to G401 breakout. See Figure. |
| S360 | In body harness, approximately 3.75 cm (1.25 in) from A/T shift lock control solenoid. See Figure. |
| S361 | In body harness, approximately 3.75 cm (1.25 in) from G301. See Figure. |
| S401 | In body harness, approximately 14 cm (6 in) from G401. See Figure. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
