Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Pontiac Torrent AWDFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Remove the injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.4L.
- Disconnect the ignition coil/control module electrical connectors.
- Remove the spark plug wire retainer (1) from the ignition control module bracket.
- Remove the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
- Position the ignition coil/control module aside out of the way.
- Remove the bolt (3) from the fuel injector wire harness bracket (4) and positive crankcase ventilation (PCV) valve fresh air tube retainer.
- Remove the engine wire harness retainers from the ignition control module bracket studs (5).
- Remove the nut (1) retaining the heater outlet pipe.
- Lift pipe up slightly to gain access for the removal of the 2 ignition control module bracket bolts.
- Remove the ignition control module bracket bolts (2).
- Remove the ignition control module bracket nuts (6).
- Remove the ignition control module bracket.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
