2006 Pontiac Torrent AWDFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Remove the injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.4L.
  2. Fig 1: View Of Ignition Coil/Control Module
    GM1422425Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the spark plug wires. Note the position from which the wires are removed.
  4. Disconnect the ignition coil/control module electrical connectors.
  5. Remove the 4 bolts securing the ignition coil/control module to the ignition control module bracket.
  6. Remove the ignition coil/control module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.