2006 Pontiac Torrent AWDFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Body Control Module (BCM) Center of dash, behind HVAC control module. See Figure.
Electronic Brake Control Module (EBCM) Below brake master cylinder. See Figure.
Heated Seat Control Module - Driver Under left front seat. See Figure.
Heated Seat Control Module - Front Passenger Under right front seat. See Figure.
HVAC Control Module At center of dash. See Figure.
Ignition Control Module (ICM) At top left side of engine. See Figure.
Inflatable Restraint I/P Module Behind top right side of dash. See Figure.
Inflatable Restraint Roof Rail Module - Left Behind headliner, above driver. See Figure.
Inflatable Restraint Roof Rail Module - Right Behind headliner, above front passenger. See Figure.
Inflatable Restraint Sensing & Diagnostic Module (SDM) Under rear of center console. See Figure.
Inflatable Restraint Steering Wheel Module In center of steering wheel. See Figure.
Power Steering Control Module (PSCM) Base of steering column. See Figure.
Powertrain Control Module (PCM) In engine compartment, mounted on top of battery cover. See Figure.
Sunroof Control Module Right rear of sunroof module assembly. See Figure.
Throttle Actuator Control (TAC) Module Attached to throttle body. See Figure.
Transmission Control Module (TCM) At left side of engine compartment.
Vehicle Communication Interface Module (VCIM) Attached to brake pedal bracket. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.