Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Pontiac Solstice AutomaticFACTORY OEM SERVICE PROCEDURE
Data Communication Component Views
WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | I/P Carrier |
| 2 | Inflatable Restraint Steering Wheel Module |
| 3 | Steering Column |
| 4 | Body Control Module (BCM) |
| Callout | Component Name |
|---|---|
| 1 | I/P Carrier |
| 2 | G202 |
| 3 | G201 |
| 4 | G200 |
| 5 | G204 (9C1, 9C3) |
| 6 | C210 |
| 7 | Spot Lamp - Right Connector (9C1, 9C3) |
| 8 | Fuse Block - I/P C2 |
| 9 | C360 (9C1 and 9C3) |
| 10 | C362 (9C1 and 9C3) |
| 11 | C200 |
| 12 | C267 (9C1 and 9C3) |
| 13 | C266 (9C1 and 9C3) |
| 14 | C297 (9C1 and 9C3) |
| 15 | HVAC Control Module C2 |
| 16 | Splice Pack SP205 |
| 17 | Splice Pack SP 206 and Splice Pack SP207 |
| 18 | C201 |
| 19 | Data Link Connector (DLC) |
| 20 | C203 |
| 21 | C250 |
| Callout | Component Name |
|---|---|
| 1 | G301 |
| 2 | C223 - Taped to Harness (9C1,9C3) |
| 3 | C250 |
| 4 | C203 |
| 5 | Terminator Resistor-Taped to Harness (w/o UE1) |
| Callout | Component Name |
|---|---|
| 1 | Vehicle Communication Interface Module (VCIM) (UE1) |
| 2 | Backup Battery (UE1 Late Production) |
| 3 | Terminator Resistor (w/UE1) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
