2006 Pontiac Solstice AutomaticFACTORY OEM SERVICE PROCEDURE

Communication Interface Module Replacement

Fig 1: Communication Interface Module Replacement
GM1582933Courtesy of GENERAL MOTORS CORP.
Communication Interface Module Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .

Preliminary Procedures

  1. Remove the front seat back body panel. Refer to Front Seat Back Body Panel Replacement .
  2. Program the communication interface module (OnStar®) after replacement. Refer to Control Module References .
1 Bolt/Screw, Communication Interface Module Bracket

Tighten:  10 N.m (89 lb in)

2 Module Assembly, Communication Interface
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.