2006 Pontiac Grand Prix BaseFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    IMPORTANT: It is necessary to record the remaining engine oil life. If the replacement module is not programed with the remaining engine oil life, the engine oil life will default to 100 percent. If the replacement module is not programmed with the remaining engine oil life, the engine oil will need to be changed at 5 000 km (3,000 mi) from the last engine oil change.
  1. Using a scan tool, retrieve the percentage of remaining engine oil. Record the remaining engine oil life.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (RPOs L26/L32) or Battery Negative Cable Disconnect/Connect Procedure (RPO LS4) .
  3. Remove the left front inner fender brace. Refer to Brace Replacement - Front Fender Upper Diagonal .
  4. Remove the air cleaner. Refer to Air Cleaner Assembly ReplacementΒ .
  5. Fig 1: View Of PCM
    GM1576575Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the PCM electrical connectors
  7. Fig 2: Removing/Installing PCM
    GM1576577Courtesy of GENERAL MOTORS CORP.
  8. Remove the PCM from the air cleaner lower housing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.