2005 Pontiac Grand Prix GXPFACTORY OEM SERVICE PROCEDURE

Installation Procedure

IMPORTANT: DO NOT reuse the throttle body gasket. Install a NEW gasket during assembly.
    Fig 1: Throttle Body Assembly
    GM1411898Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW throttle body gasket (509). Align the locating tab of the gasket with the notch in the manifold.
  2. Position the throttle body (508) to the intake manifold.
  3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the throttle body bolts (538).

    Tighten:Β  Tighten the bolts to 10 N.m (89 lb in).

  5. Fig 2: View Of Electrical Connectors
    GM1551867Courtesy of GENERAL MOTORS CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.