2005 Pontiac Grand Am SC/TFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Turn OFF the ignition.
  2. Fig 1: Removing/Installing Accelerator Cable & Components
    GM12287Courtesy of GENERAL MOTORS CORP.
  3. Remove the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left (Outboard) or Closeout/Insulator Panel Replacement - Left (Inboard) in Instrument Panel, Gauges, and Console.
  4. Disconnect the accelerator cable (5) from the accelerator pedal (1).
  5. Squeeze the accelerator cable cover tangs and push the accelerator cable through the bulkhead.
  6. Fig 2: Identifying Throttle Cable Bracket With Cables
    GM12735Courtesy of GENERAL MOTORS CORP.
  7. Remove the accelerator cable shield, if equipped.
  8. Disconnect the accelerator cable from the retaining clip.
  9. Disconnect the accelerator cable from the throttle body lever.
  10. Disconnect the cruise control cable from the accelerator cable bracket.
  11. Disconnect the accelerator cable from the accelerator cable bracket.
  12. Fig 3: Identifying Accelerator Cables
    GM12734Courtesy of GENERAL MOTORS CORP.
  13. Remove the accelerator cable from the vehicle noting cable routing.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.