2005 Pontiac Grand Am SC/TFACTORY OEM SERVICE PROCEDURE

Removal Procedure

    Fig 1: Removing/Installing Accelerator & Cruise Control Cables From Accelerator Cable Bracket
    GM294522Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the accelerator and cruise control cables from the throttle body lever.
  2. Depress the tangs and remove the accelerator and cruise control cables from the accelerator cable bracket.
  3. Fig 2: Identifying Cruise Control Cable
    GM319387Courtesy of GENERAL MOTORS CORP.
  4. If applicable disconnect the cruise control cable from the throttle lever and accelerator bracket.
  5. Fig 3: View Of Accelerator Cable Bracket
    GM12689Courtesy of GENERAL MOTORS CORP.
  6. Remove the nuts and bolts holding the accelerator cable bracket to the throttle body.
  7. Remove the accelerator cable bracket.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.