Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Pontiac GTO AutomaticFACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect each spark plug gap. Adjust each plug as needed.
Specification: Spark plug gap: 1.016 mm (0.040 in)
- Hand start the spark plugs in the corresponding cylinders.
- Tighten the spark plugs.
Tighten:
- For cylinder head-new: Tighten the spark plugs to 20 N.m (15 lb ft).
- For cylinder head-all subsequent installations: Tighten the spark plugs to 15 N.m (11 lb ft).
- Install the spark plug wires. Refer to Spark Plug Wire Replacement .
- Install the fuel rail covers.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.