2005 Pontiac G6 BaseFACTORY OEM SERVICE PROCEDURE

BASS Data List

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
BASS High During Learn

The scan tool displays NO/YES. If a short to battery positive voltage is detected in the stop lamp switch signal circuit during calibration, then the scan tool will display YES.

BASS Learned

The scan tool displays NO/YES. When the brake pedal position sensor has been calibrated correctly, the scan tool will display YES.

BASS Low During Learn

The scan tool displays NO/YES. If a short to ground is detected in the stop lamp switch signal circuit during calibration, then the scan tool will display YES.

BASS Moved During Learn

If the brake pedal is moved during calibration, the scan tool will display YES.

BASS Valid

The scan tool displays NO/YES. When the brake pedal position sensor has been calibrated correctly, the scan tool will display YES.

Brake Lamp

The scan tool displays ON/OFF. When the brake is applied the scan tool will display ON.

Current Position

The scan tool displays COUNTS. The brake pedal position sensor applies a varying voltage to the BCM. The BCM then calculates the current position of the brake pedal.

Learned Home Position

The scan tool displays COUNTS. The BCM displays the home position of the brake pedal position sensor.

Learn in Progress

The scan tool displays NO/YES. When the brake pedal position sensor is being calibrated, the scan tool will display YES.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.