Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Pontiac G6 BaseFACTORY OEM SERVICE PROCEDURE
Theft Deterrent Programming Procedures
IMPORTANT:
If any module or device listed is replaced, programming of the module must be done prior to performing the theft deterrent programming procedure.
Perform the theft deterrent programming procedure if any of the following components have been replaced:
- The body control module (BCM)
- The powertrain control module (PCM)
Refer to Programming Theft Deterrent System Components in Theft Deterrent for the proper procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.