2005 Pontiac Aztek Base, FWDFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Turn the ignition OFF.
  2. Fig 1: View Of Air Cleaner Upper Cover
    GM1404634Courtesy of GENERAL MOTORS CORP.
  3. Remove the air cleaner upper cover. Refer to Air Cleaner Assembly Replacement in Engine Controls - 3.6L (LY7).
  4. Fig 2: Identifying Transmission Control Module
    GM1395508Courtesy of GENERAL MOTORS CORP.
  5. Remove the transmission control module from the air cleaner.
  6. Disconnect the transmission control module electrical connectors from the transmission control module.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.