2005 Pontiac Aztek Base, FWDFACTORY OEM SERVICE PROCEDURE

Cruise Control Connector End Views

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
Cruise Control Module Terminal Identification(CCM)

GM666638Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12177081
  • 10-Way F GT 150 (BLK)
Pin Wire Color Circuit No. Function
A GRY 397 Cruise Control On Switch Signal
B DK BLU 84 Cruise Control Set/Coast Switch Signal
C GRY/BLK 87 Cruise Control Resume/Accel Switch Signal
D BRN 86 Cruise Control Release Signal
E BLK/WHT 451 Ground
F BRN 141 Ignition 3 Voltage
G WHT 17 Stop Lamp Switch Signal
H DK GRN 83 Cruise Control Inhibit Signal
J WHT 85 Cruise Control Engaged Signal
K DK GRN 389 Vehicle Speed Signal
Cruise Control Release Switch Terminal Identification

GM287957Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12041433
  • 2-Way F Metri-Pack 280 Series (BLK)
Pin Wire Color Circuit No. Function
A BRN 86 Cruise Control Release Signal
B BRN 241 Ignition 3 Voltage
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.