Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2005 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.

Align the tabs on the switch with the slots in the floor console.

Fig 1: Aligning Tabs On Traction Control Switch

Courtesy of GENERAL MOTORS CORP.

Press the traction control switch through the opening in the floor console.

Fig 2: Pressing Traction Control Switch

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector.

Fig 3: View Of Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.

Chapter Navigation

Return to Chapter: Traction Control Switch Replacement

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.