2005 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the traction control switch (1) to the IP cluster trim plate (2).
  2. Fig 1: Installing Traction Control Switch To Cluster Trim Plate (Impala)
    GM814200Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (1) to the traction control switch (2).
  4. Fig 2: Connecting Traction Control Switch Electrical Connector (Impala)
    GM814203Courtesy of GENERAL MOTORS CORP.
  5. Align and carefully press the IP cluster trim plate into the IP trim pad. Make sure all of the retainers are fully engaged.
  6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the LH IP cluster trim plate screws.

    Tighten:Β  Tighten the IP cluster trim plate screws to 2 N.m (18 lb in).

  8. Install the LH instrument panel (IP) fuse block access opening covers.
  9. Install the ignition switch cylinder bezel.
  10. Return the steering wheel to the original position.
  11. If equipped with a column shift, position the transaxle shift control indicator to Park.
  12. If equipped with column shift, release the parking brake.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.