Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE
Section 12 (Interior Trim)
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Repair Instructions
- Eliminating Unwanted Odors in Vehicles
- Carpet Retainer Replacement - Front
- Floor Carpet Drying
- Carpet Replacement - Front
- Sound Barrier Replacement - Rear Seat Back
- Headliner Replacement (Impala)
- Headliner Replacement (Monte Carlo)
- Assist Handle Replacement - Front
- Assist Handle Replacement - Rear
- Coat Hook Replacement
- Console Replacement - Overhead
- Roof Console Retainer Replacement
- Sunshade Replacement
- Sunshade Anchor Replacement
- Garnish Molding Replacement - Windshield Pillar (Impala)
- Garnish Molding Replacement - Windshield Pillar (Monte Carlo)
- Trim Panel Replacement - Upper Center Pillar (Impala)
- Trim Panel Replacement - Lower Center Pillar (Impala)
- Trim Panel Replacement - Rear Quarter Upper (Impala)
- Trim Panel Replacement - Rear Quarter Upper (Monte Carlo)
- Trim Panel Replacement - Rear Quarter Lower (Impala)
- Trim Panel Replacement - Rear Quarter Lower (Monte Carlo)
- Trim Panel Replacement - Rear Window Shelf (Impala)
- Trim Panel Replacement - Rear Window Shelf (Monte Carlo)
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
