Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Pontiac Vibe GTFACTORY OEM SERVICE PROCEDURE
Removal Procedure
NOTE:
The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.
- Remove the inlet air duct from between the air cleaner and throttle body.
- Remove the 2 fasteners (3) from the throttle position (TP) sensor (2).
- Remove the TP sensor (2) from the throttle body.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.