2004 Pontiac Vibe GTFACTORY OEM SERVICE PROCEDURE

Installation Procedure

    Fig 1: Air Cleaner Components
    GM847995Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner lower assembly (4) to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the air cleaner lower assembly to the vehicle with 3 bolts (5).

    Tighten:  Tighten the 3 bolts to 7 N.m (62 lb in).

  3. Install the air cleaner element (3) into the air cleaner lower assembly (4).
  4. Install the air cleaner upper assembly (2) onto the air cleaner lower assembly (4).
    5. Fig 2: Air Inlet Duct Clamp, Throttle Body, And Retaining Clips
    GM847992Courtesy of GENERAL MOTORS CORP.
  5. Secure the air cleaner upper assembly (2) with the two retaining clips (3).
  6. Connect the air inlet duct to the throttle body (1).
  7. Secure the air inlet duct with the hose clamp.
  8. Connect the vacuum hoses of the auxiliary intake air control system.
  9. Install the auxiliary intake air control solenoid to the air cleaner cover. Refer to Auxiliary Intake Air Control Solenoid Replacement .
  10. Install the EVAP canister purge valve to the air cleaner cover. Refer to Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement .
  11. Install the EVAP canister vent valve to the air cleaner cover. Refer to Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement .
  12. Connect the MAF sensor.
  13. Install the accelerator cable into the cable guide wire.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.