Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Pontiac Vibe AWD L4-1.8L VIN 8FACTORY OEM SERVICE PROCEDURE
Cruise Control Module: Service and Repair
CRUISE CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE

1. Remove the instrument panel cluster trim plate.
2. Remove the instrument panel cluster assembly.
3. Disconnect the cruise control module electrical connector.
4. Remove the following components from the vehicle:
- The cruise control module mounting bolt
- The cruise control module
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.

1. Install the cruise control module to the IP. Secure the module with the mounting bolt.
Tighten
Tighten the cruise control module mounting bolt to 10 N.m (89 lb in).
2. Connect the cruise control module electrical connector.
3. Install the instrument panel cluster assembly.
4. Install the instrument panel cluster trim plate.
REMOVAL PROCEDURE
1. Remove the instrument panel cluster trim plate.
2. Remove the instrument panel cluster assembly.
3. Disconnect the cruise control module electrical connector.
4. Remove the following components from the vehicle:
- The cruise control module mounting bolt
- The cruise control module
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the cruise control module to the IP. Secure the module with the mounting bolt.
Tighten
Tighten the cruise control module mounting bolt to 10 N.m (89 lb in).
2. Connect the cruise control module electrical connector.
3. Install the instrument panel cluster assembly.
4. Install the instrument panel cluster trim plate.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
