2004 Pontiac Sunfire AutomaticFACTORY OEM SERVICE PROCEDURE

Removal Procedure

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief ProcedureΒ .
  2. Disconnect the vacuum pipe from the fuel pressure regulator.
    Fig 1: View Of Fuel Pressure Regulator Vent Pipe
    GM870490Courtesy of GENERAL MOTORS CORP.
  3. Place a shop towel under the fuel pressure regulator in order to catch any fuel spillage.
  4. Remove the retaining bolt (1) from the fuel pressure regulator.
    Fig 2: Locating Fuel Pressure Regulator Retaining Bolt
    GM870632Courtesy of GENERAL MOTORS CORP.
  5. Remove the fuel pressure regulator.
    Fig 3: Identifying Fuel Pressure Regulator
    GM870630Courtesy of GENERAL MOTORS CORP.
  6. Remove any seal or seal material left on the fuel rail.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.