Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Pontiac Sunfire AutomaticFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Depress the accelerator control cable tangs (1) from the pedal lever assembly.
- Remove the accelerator control cable from the pedal lever assembly.
- Remove the cruise control cable (1), if applicable.
- Release the accelerator control cable lug (3) from the throttle body assembly (4).
- Depress the tangs on the control cable (2) while pulling the cable through the control cable bracket (1).
- Remove the control cable from the bracket.
- Disconnect the control cable (2) from the support clip (1).
- Remove the cable from the vehicle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.