Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Pontiac GTO AutomaticFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Disconnect the MAF sensor (2) wiring harness connector.
- Disconnect the IAT sensor (3) wiring harness connector.
- Loosen the clamp on air duct adaptor closest to the air cleaner upper housing (1).
- Loosen the clamp on the intake air duct at the MAF sensor (2) and pull back the intake air duct to clear the sensor
- Remove the MAF sensor (2).
IMPORTANT:
The air duct adaptor (between air cleaner and MAF sensor), retaining clamps, air duct and MAF sensor, all have locating notches.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
