Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Pontiac GTO AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| Automatic Transmission Fluid Pressure (TFP) Manual Valve Position Switch | Inside transmission. See Figure . |
| Back-Up Lamp Switch | Part of PNP switch. |
| Brake Fluid Level Switch | In master cylinder reservoir. |
| Clutch Pedal Position Switch | Above clutch master cylinder. |
| Engine Oil Pressure (EOP) Switch | Top rear of engine. See Figure . |
| Park Brake Switch | In center console. |
| PNP Switch | On left side of transmission. See Figure . |
| Rear Compartment Lid Ajar Switch | On left rear compartment lid latch. |
| Stop Lamp Switch | On top of brake pedal support. |
| Stop Lamp Switch Connector | Near top of brake pedal. See Figure . |
| Stoplamp, Traction And Cruise Control Release Switch Connector | Near top of brake pedal. See Figure . |
| Windshield Washer Fluid Level Switch | Right side of engine compartment, inside solvent container. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.