WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

Install the accelerator controls cable bracket to the throttle body.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the accelerator controls cable bracket bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 1: Installing Accelerator Controls Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Install the accelerator cable (2) to the throttle body lever.
Install the accelerator cable (2) to the bracket (1).

Fig 2: Installing Accelerator Cable

Courtesy of GENERAL MOTORS CORP.

Install the cruise control cable (1) to the bracket (2).
Install the cruise control cable to the throttle body lever.

Fig 3: Installing Cruise Control Cable

Courtesy of GENERAL MOTORS CORP.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Installation Procedure

Use the Manual With the Right Hardware

When to See a Mechanic

Rather have a pro handle this?