Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Liftgate Control Module Programming
- The liftgate module (LGM) must be programmed with the proper RPO configurations. The LGM stores the information regarding the vehicle options. If the LGM is not properly configured with the correct RPO codes the LGM will not control the features properly. Ensure that the following conditions exist in order to prepare for the LGM programming:
- The battery is fully charged.
- The ignition switch is in the RUN position.
- The data link connector (DLC) is accessible.
- Follow the instructions on the Techline Terminal and scan tool to program the LGM.
- If the LGM fails to accept the program, perform the following steps:
- Inspect all LGM connections.
- Verify that the Techline Terminal and scan tool have the latest software version.
If the liftgate module has been replaced, you must also reprogram the key Fobs.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.