2004 Pontiac Aztek Base, FWDFACTORY OEM SERVICE PROCEDURE

HVAC Control Module Connector End View

HVAC Control Module Connector End View

GM130690Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12110206
  • 24-Way F Micro-Pack 100 Series (LT BLU)
Pin Wire Color Circuit No. Function
A1 BLK 552 Low Reference
A2 - - Not Used
A3 WHT 2622 Evaporator Temperature Sensor Signal
A4 LT BLU/BLK 590 Sunload Sensor Signal
A5-A6 - - Not Used
A7 GRY/BLK 754 Blower Motor Speed Control
A8 ORN 761 Blower Motor Speed Signal
A9 - - Not Used
A10 BLK 150 Ground
A11 BRN 241 Ignition 3 Voltage
A12 ORN 640 Battery Positive Voltage
B1 DK BLU 1646 Right Air Temperature Door Position Signal
B2 LT BLU 733 Left Air Temperature Door Position Signal
B3 YEL/BLK 713 Mode Door Position Signal
B4 GRY 598 5-Volt Reference
B5 WHT/BLK 1236 Right Air Temperature Door Control
B6 DK BLU 1199 Left Air Temperature Door Control
B7 TAN 2273 Mode Door Control
B8 TAN/BLK 2274 Recirculation Door Control
B9 WHT 1038 Class 2 Serial Data
B10 - - Not Used
B11 WHT 193 Rear Defog Relay Control
B12 GRY 8 Instrument Panel Lamp Supply Voltage
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.