Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE
Data Link Communications Connector End Views
WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Data Link Connector Terminal Identification - (DLC)
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit Number | Function |
| 1 | - | - | Not Used |
| 2 | PU | 1132 | Class 2 Serial Data |
| 3 | - | - | Not Used |
| 4 | BK | 150 | Ground |
| 5 | BK/WH | 1551 | Ground |
| 6-15 | - | - | Not Used |
| 16 | OG | 2340 | Battery Positive Voltage |
Splice Pack Terminal Identification - SP 205
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit Number | Function |
| A | PU | 1132 | DLC Class 2 Serial Data |
| B | D-GN | 1049 | PCM Class 2 Serial Data |
| C | YE | 1127 | Trip Computer Class 2 Serial Data |
| D | OG | 1044 | Radio Class 2 Serial Data |
| E | L-BU | 1122 | ABS/TCS Class 2 Serial Data |
| F | D-BU | 1128 | SDM Class 2 Serial Data |
| G | GY | 1036 | IPC Class 2 Serial Data |
| H | - | - | Not Used |
| J | L-GN | 2271 | ADG Class 2 Serial Data (UE1) |
| K | BN/WH | 1048 | HUD Class 2 Serial Data (UV6) |
| L | WH | 1038 | HVAC Class 2 Serial Data |
| M | L-GN | 1037 | BCM Class 2 Serial Data |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
