Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Pontiac Aztek Base, AWDFACTORY OEM SERVICE PROCEDURE
Section 195 (Antilock Brake System And Traction Control System)
WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Antilock Brake System
- Diagnostic System Check - ABS
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- Enhanced Diagnostics
- DTC B2747
- DTC C1214
- DTC C1216
- DTC C1217
- DTC C1218
- DTC C1221-C1235
- DTC C1236
- DTC C1237
- DTC C1238
- DTC C1242 or C1243
- DTC C1248
- DTC C1254
- DTC C1255 or C1256
- DTC C1261-C1274
- DTC C1276, P1644, or P1689
- DTC C1277 or P0856
- DTC C1278
- DTC C1291
- DTC C1294
- DTC C1295
- Symptoms - Antilock Brake System
- ABS Indicator Always On
- ABS Indicator Inoperative
- Traction Off Indicator Always On
- Traction Off Indicator Inoperative
- Repair Instructions
- ABS Automated Bleed Procedure
- Electronic Brake Control Module Replacement
- Brake Pressure Modulator Valve (BPMV) Replacement
- Brake Pressure Modulator Valve (BPMV) Bracket Replacement
- Wheel Speed Sensor Replacement - Front
- Wheel Speed Sensor Replacement - Rear
- Traction Control Switch Replacement (Impala)
- Traction Control Switch Replacement (Monte Carlo)
- Description and Operation
- Special Tools and Equipment
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
