Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions: Inputs
- Courtesy Lamp Switch
-
The scan tool displays Inactive/Active. The input of the courtesy lamp switch is displayed as Active when the courtesy lamps are on.
- Fog Lamp Switch
-
The scan tool displays Inactive/Active. The input of the fog lamp switch is displayed as active if the fog lamp switch is turned on.
- Headlamp Switch
-
The scan tool displays Inactive/Active. The input of the headlamp switch is displayed as active when the headlamps switch is On.
- Hi Beam On Switch
-
The scan tool displays Inactive/Active. The input of the high beam switch is displayed as active when the high beam headlamps are turned on.
- Park Brake Switch
-
The scan tool displays inactive or active. When the park brake is Off, the scan tool will display inactive. When the park brake is applied, the scan tool will display active.
- Park Lamp Switch
-
The scan tool displays On/Off. The input of the park lamp switch is displayed as On when the park lamps are command On.
- Surveillance Mode Switch
-
The scan tool displays Inactive/Active. The input of the emergency vehicle interior lamp switch is displayed as active if the switch is turned to the off position.
- Theater Dim 1 Ground
-
The scan tool displays Inactive/Active. The input of the theater dim 1 ground is displayed as active when the ground is present at the BCM for the theater dim lamps.
- Theater Dim 2 Ground
-
The scan tool displays Inactive/Active. The input of the theater dim 2 ground is displayed as active when the ground is present at the BCM for the theater dim lamps.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
